1.Wet Scrubber Introduction
We specialize in lime hydrating machine for several years with proven technology which used for producing powder material. Our company is professional in design and manufacturing various wet scrubber for various lime factories and lime filed. Another aspect of lime hydrating plants design is the absolute need to minimize the particulate emissions. Today 50 mg/Nm3 is generally an accepted value.
Wet scrubbers can meet the standards..
2.Wet Scrubber Parameter (Specification)
Realize the cycling usage of water and the reuse of overflow dust
Recycle waste heat of hot steam which can improve the percent conversion of lime, save energy and solve the dust pollution problem and raise working efficiency finally.
(1)Dust collecting rate: up 99%
(2)Dust removal effect: Dustiness at the vent of dust collector is less than 30 mg/m3
3.Wet Scrubber Feature And Application
The dust collector is mainly used to remove dust and steam comes out during the hydration. It can match lime hydrator, lime slaker and other equipment to meet various requirements of clients. Dust and steam enter dust removal water tank through dust cage and dust pipe. After complete treating with the dust, discharge clean gas from the vent. During solving dust and steam, water in cabin turns out hot slime water by absorbing dust and steam, then via high pressure pump, throwing into pipes of water cycling system for the lime hydration.
4.Wet Scrubber Details
The operation principle is based on the agglomeration, by sprayed water, of the dust particles contained in the process exhaust gases, that are then separated in a cyclone.
The quantity of scrubbing water matches to the hydration process requirements and in standard conditions of operation no slurries or other waste products are generated.
Once the hydrator is stopped with material feed shut-down, the system ensures full scrubbing action for more than 15 minutes, in order to dedust the last gas coming from the reaction chamber.
We would like to precise that, in case of good quality lime (CaO higher than 86%), the system foresee the complete use of the powder dragging water of the hydration cycle.
In case of lower quality of lime we can guarantee the above limit value, but excess water will be discharged out of the hydration cycle.
5.Wet Scrubber Qualification
Our wet scrubber matched with lime hydrating machine.
6.Deliver,Shipping And Serving
We not only design and manufacture lime hydrating line for customer, but also provide aftersales technical assistance service, called turn-key projects.
(1)How many days you need to install the equipment?
Generally speaking total installation period is about 30 days.
(2)How many staff abroad you sent to install the equipment?
Generally speaking we dispatch three engineers as interpreter, electrical engineer and one mechanical engineer.
(3)You have sales target finished amount requirement to the distributor?
Sales target should be one lime engineering project which about 200000 usd that could be our distributor.
(4)Can I transfer the money to you then you pay to other supplier?
We take charge to design and fabricate for customer.
(5)Can I delivery the goods from other supplier to your factory? Then load together?
Yes, could be.
(6)If OEM is acceptable?
(7)Can I only buy some spare parts from you?
YES, definitely could.
(8)How long it takes you to provide the designing options for us?
After discussion, we take one day to provide technical proposal.
(9)Can you can design the equipment according to our size?
(10)Can the equipment be installed under hot weather? And can Your products be installed under the cold weather?
Yes,it could be.